MCQOPTIONS
Bookmark
Saved Bookmarks
→
Microprocessors
→
Semiconductor Memory Interfacing
→
Which language could be used for programming an FP...
1.
Which language could be used for programming an FPGA.
A.
Verilog
B.
VHDL
C.
Both A and B
D.
None of the above
Answer» D. None of the above
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
The BIU contains FIFO register of size 6 bytes called _____.
In a microprocessor system, suppose. TRAP, HOLD, RESET Pin got activated at the same time, while the processor was executing some instructions, then it will first respond to
The _________ translates a byte from one code to another code.
When CPU is not fully loaded, which of the following method of data transfer is preferred
In microprocessor, the SS is called as ________.
The CS register stores instruction _____________ in code segment.
The BIU contains FIFO register of size __________ bytes.
The microprocessor determines whether the specified condition exists or not by testing the ______.
The BIU pre-fetches the instruction from memory and store them in ________.
Which RAM is created using MOS transistors ?
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies