What is the objective of doing mechanical compaction after laying each – McqOptions

MCQOPTIONS

1.	What is the objective of doing mechanical compaction after laying each layer?
A.	To obtain maximum moisture content
B.	To obtain minimum dry density
C.	To obtain maximum dry density at optimum moisture content
D.	To increase coarse grain content
Answer» D. To increase coarse grain content

Discussion

No Comment Found

Related MCQs

In which method of Plate laying a temporary line is laid by side the of the proposed railway track?
Which of the following is not a part of Plate laying or Track linking?
What are the factors on which the design of Bridges of railway are dependent?
Why is the section where earthwork is to be donedivided into different zones?
Which curve is used to determine the economical lead of moving earth in the longitudinal direction?
What is the objective of doing mechanical compaction after laying each layer?
Why is the Formation of an embankment preferred over formation in a cutting?
What does the slide slope provided for the embankment depends upon?
If we want to construct a single line railway track, the land available should be adequate for the construction of a double line.
Where should one refer to for the procedure of acquisition of land with the help of member state government?