To derive 18 V and 12 V from a 24 V supply requires a voltage divider – McqOptions

MCQOPTIONS

1.	To derive 18 V and 12 V from a 24 V supply requires a voltage divider with three taps.
A.	rue
B.	alse
Answer» B. alse

Discussion

No Comment Found

Related MCQs

A certain Wheatstone bridge has the following resistor values: R1 = 10 kΩ, R2 = 720 Ω, and R4 = 2.4 kΩ. The unknown resistance is_____________?
A certain circuit is composed of two parallel resistors. The total resistance is 1,403 Ω. One of the resistors is 2 kΩ. The other resistor value is____________?
A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is____________?
A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are___________?
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately___________?
A galvanometer is a meter that measures small amounts of voltage.
A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
The higher the range setting, the less the internal resistance and the greater the load effect of the voltmeter on a circuit.
A balanced Wheatstone bridge consists of an RV of 3,500 Ω, an R2 of 200 Ω, and an R3 of 680 Ω. The value of RUNK is