Those magnetic materials are best suited for making armature and trans – McqOptions

MCQOPTIONS

1.	Those magnetic materials are best suited for making armature and transformer cores which have____permeability and_______hystersis loss.
A.	high, high
B.	low, high
C.	high, low
D.	low, low
Answer» D. low, low

Discussion

No Comment Found

Related MCQs

Voltage applied across a ceramic dielectric produces an electrolytic field 100 times greater than air. What will be the value of dielectric constant ?
"The total electric flux through any closed surface surrounding charges is equal to the amount oflcharge enclosed". The above statement is associated with
The time constant of an R-C circuit is defined as the time during which capacitor charging voltage actually rises to ______ percent of its______value.
While comparing magnetic and electric circuits, the flux of magnetic circuit is compared with which parameter of electrical circuit ?
A rectangular magnet of magnetic moment M is cut into two piece of same length, the magnetic moment of each piece will be
The self-inductance of the coil may be defined as equal to the e.m.f. induced in volts when the current in the circuit changes at the rate of unit weber turns.
A conductor 2 metres long moves at right angles to a magnetic field of flux density 1 tesla with a velocity of 12.5 m/s. The induced e.m.f. in the conductor will be
The polarity of the induced voltage can be determined by using the left-hand generator rule.
Two infinite parallel plates 10 mm apart have maintained between them a potential difference of 100 V. The acceleration of an electron placed between them is
The initial rate of rise of current through a coil of inductance 10 H when suddenly connected to a D.C. supply of 200 V is_______Vs