The moist feed is fed in at the _________ end of a rotary dryer and t – McqOptions

MCQOPTIONS

1.	The moist feed is fed in at the _________ end of a rotary dryer and the material progresses to the ________ end, where it gets discharged.
A.	Upper and Lower
B.	Lower and Upper
C.	Lower and Lower
D.	Upper and Upper
Answer» B. Lower and Upper

Discussion

No Comment Found

Related MCQs

In fluidised-bed dryers, a separate component is provided in which the solids move sequentially from the inlet to outlet, such setup is known as ______________ where the residence time is more or less the same for all particles in that compartment.
Fluidised bed dryers work best with which of the following bed material?
For a fluidised bed dryer, which one of the following is correct?
Which one of the following is not an advantage of flash dryers?
Which one of the following dryers have high drying rate but low residence time?
Which one of the following dryers are best suited for drying of heat sensitive or easily oxidizable materials?
A flash dryer is similar in its operation to a _________ as the feed is dispersed finely in an upward flowing hot air.
Which one of the following is the most flexible continuous flow dryer?
Drum dryer mainly handles the materials that are too thick for a spray dryer and too thin for a rotary dryer.
For a single drum, the thickness of the film can be controlled by ___________ and in case of a double drum setup the thickness of product here can be controlled by ______________