The initial value of checksum is – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Internet of things (IoT)
→ Multithreading in Internet of things (IoT)
→ The initial value of checksum is..

1.	The initial value of checksum is
A.	-1
B.	2
C.	1
D.	0
Answer» E.

Discussion

No Comment Found

Related MCQs

In NAT, the range of addresses for private networks from 10.0.0.0 to 10.255.255.255 makes a total of
In IPv4 addressing, a block of addresses can be defined as
In classful addressing, a large part of the available addresses are
In IPv6, each packet is composed of a mandatory base header followed by the
The dotted-decimal notation is used to make an IPv4 address more compact and easier to
In multicast address of IPv6, the value of the prefix is
A sender can choose a route so that its datagram does not travel through
Datagram network uses the universal addresses defined in the network layer to route packets from the source to the
The Configuration management can be divided into two subsystems which are
In the IPv4 layer, the datagrams are the

Related Topics

Multithreading in Internet of things (IoT)

Designing Emerging Technology in Internet of things (IoT)

Rasberry Pi in Internet of things (IoT)

Proximity Sensor in Internet of things (IoT)

Coap Protocol in Internet of things (IoT)

Iot Architecture Smartgrid in Internet of things (IoT)

Humidity Sensor in Internet of things (IoT)

Cloud Powerful Smart Mobile Devices in Internet of things (IoT)

Spi Protocol in Internet of things (IoT)

Iot Architecture Smartcities in Internet of things (IoT)

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com