MCQOPTIONS
Bookmark
Saved Bookmarks
→
Power Systems
→
Sag Tension Vibrations Dampers in Power Systems
→
The fuel cost functions of two powr plants are..
1.
The fuel cost functions of two powr plants are
A.
1: 4
B.
2: 3
C.
3: 2
D.
4: 1
Answer» E.
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
A power system has two synchronous generators. The governor-turbine characteristics orresponding to the generators are <br>P<sub>1</sub> = 50(50 ), P<sub>2</sub> = 100(51 ). where f denotes the system frequency in Hz and P<sub>1</sub> and P<sub>2</sub> are respectively, the power outputs (in MW) of turbines 1 and 2. Assuming the generat or s and transmission network to be lossless, the system frequency for a total load of 400 MW is __________ Hz
Determine the correctness or otherwise of the following Assertion [a] and the Reason [r]. <b>Assertion:</b> Fast decoupled load flow method gives approximate load flow solution because it uses several assumptions. <br><b>Reason:</b> Accuracy depends on the power mismatch vector tolerance.
The fuel cost functions of two powr plants are <br>Plant P<sub>1</sub> : C<sub>1</sub> = 0.05 Pg <sub>1</sub> + APg<sub>1</sub> + B <br>Plant P<sub>2</sub> : C<sub>2</sub> = 0.10 Pg <sub>2</sub> + APg<sub>2</sub> + 2B <br>Where, P<sub>g1</sub> and P<sub>g2</sub> are the generated powers of two plants, and A and B are the constants. If the two plants optimally share 1000 MW load at increamental fuel cost of 100 Rs/MWh, the ratio of load shared by plants P<sub>1</sub> and P<sub>2</sub> is
If a 75 MVA, 10 kV synchronous generator has X<sub>d</sub> = 0.4 p.u, then X<sub>d</sub> value (in p.u.) to a base of 100 MVA, 11 kV is ___________
In a long transmission line with r, l, g and c are the resistance, inductance, shunt conductance and capacitance per unit length, respectively, the condition for distortionless transmission is
A cable has following characteristics: <br>L = 0.201 H/m and C = 196.2 p/F/m. <br>The velocity of wave propagation through the cable is ________ m/s
When a line-to-ground fault occurs, the current in the phase is 100 A. The zero sequence current in this case will be _______ A
A three phase 50 Hz line consists of three conductors each of diameter 21 mm. The spacing between the conductors as follows: A B = 3m, B C = 5m, C A = 3.6 m <br>If the line operates at 132 kV, the reactive voltampere generatd by the line per km is _______kVAr
If the sheath resistance is 2.14 /km and that of the conduct or is 0.1625 /k m, and mutual inductance of the shealth is 3.13 10<sup> 7</sup> H/m. When the cable is 2 km long and supply is 50 Hz, the ratio of sheath loss to core loss of the cable will be_______
A 50 Hz alternator is rated 500 MVA, 20 kV, with X<sub>d</sub> = 1.0 per unit and X<sub>"d</sub> = 0.2 per unit. It supplies a purely resistive load of 400 MW at 20 kV. The load is connected directly across the generator terminals when a symmetrical fault occurs at the load terminals. The initial rms current in the generator in per unit is __________
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply