The fringe effect can be neglected in a parallel plate waveguide is – McqOptions

MCQOPTIONS

1.	The fringe effect can be neglected in a parallel plate waveguide is because of:
A.	The dielectric material used
B.	Width of the plates is greater than the distance between the plates
C.	Material of the parallel plate waveguide used
D.	None of the mentioned
Answer» C.

Discussion

No Comment Found

Related MCQs

The wave impedance for a non-propagating mode in TE mode is:
If the distance between the two plates of a parallel plate waveguide is 20 mm and is operating in TE₂ mode, then the cut off frequency of TE₂ mode is:
If in a parallel plate waveguide, PL=4 mW/m and Pₒ=10 mW/m, then what is the conduction loss?
Phase velocity of the plane waves in the two direction in a parallel plate waveguide is:
For a parallel waveguide, the dominant mode for TM propagation is:
For TM2 mode, if the distance between two parallel plates of a waveguide are 40 mm, then the cut off wavelength for TM2 mode is:
In a parallel plate waveguide, for a propagating mode, the value of β is:
The wave impedance of a TM mode in a parallel plate waveguide is a:
In TM mode, if the direction of wave propagation is in ‘z’ direction, then:
If the width of a parallel plate waveguide is 30 mm and the distance between the parallel pates is 5 mm, with an intrinsic impedance of 377Ω, then the characteristic impedance of the wave is: