The critical pressure ratio for gases is – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Power Systems
→ Sag Tension Vibrations Dampers in Power Systems
→ The critical pressure ratio for gases is ..

1.	The critical pressure ratio for gases is
A.	0.528
B.	0.546
C.	0.577
D.	0.582
Answer» B. 0.546

Discussion

No Comment Found

Related MCQs

Read the statements below. I. The built up rotor is cheaper and easier to manufacture. II. The high pressure and intermediate pressure rotors are always of integral type.
The diagram efficiency is the ratio of
The critical pressure ratio for initially superheated steam is __________ as compared to initially dry saturated steam.
In an impulse turbine
The maximum efficiency of a De-Laval turbine is (where α = Nozzle angle)
The pressure of steam, in reaction turbines, is reduced in the fixed blades as well as in moving blades.
The compounding of turbines is done in order to
When the cross-section of a nozzle __________ continuously from entrance to exit, it is called a convergent nozzle.
If the critical pressure ratio for steam is 0.546, then the steam is initially
Rateau turbine is

Related Topics

Sag Tension Vibrations Dampers in Power Systems

Skin Effect Proximity Effect in Power Systems

Air Pollution in Power Systems

Cost Analysis Power Plants in Power Systems

Constituents Steam Power Plant in Power Systems

Fuel Combustion Combustion Equipments in Power Systems

Capacitance Two Wire Line in Power Systems

Effect Earth Three Phase Transmission Line Capacitance in Power Systems

Comparision Faults Three Phase System in Power Systems

Elements Hydroelectric Power Plant in Power Systems

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com