Statement 1: T-joints in pipelines for crystallization should be avoided as much as possible.Statement 2: Thin liquids should have a slope to drain off liquid.

Statement 1: T-joints in pipelines for crystallization should be avoid

1.	Statement 1: T-joints in pipelines for crystallization should be avoided as much as possible.Statement 2: Thin liquids should have a slope to drain off liquid.
A.	True, False
B.	True, True
C.	False, False
D.	False, True
Answer» C. False, False

Discussion

No Comment Found

Related MCQs

Statement 1: Resistance is inversely proportional to the inter-facial area.Statement 2: The inter-facial area of a body is the area of the dispersed phase in a unit volume of the vessel.
How does the solubility of carbon-di-oxide in coke increase when it is subjected to high pressure?
Statement 1: Diffusion of gas component through the resistive film to the bulk of the liquid is the rate determining step.Statement 2: Diffusion of gas component through the gas-liquid inter-phase is the rate determining step.
The EMC-RH data is fitted to Henderson’s equation. Which of the following is true about the relative humidity with respect to food technology terminology?
A major reason as to why evaporators and their selection for different applications in the food industry is very important is because ______
Statement 1: Penetration theory states that mass transfer coefficient is directly proportional to diffusivity coefficient which was later proved wrong.Statement 2: Penetration theory states that mass transfer is based on unsteady mass transfer.
When there is a mixture of liquids present, the boiling point lies between the boiling points of both the components.
The point where the constant drying period changes to falling rate period is called _____
Which of the following needs to be taken care of during scale up of crystallizers?
The ratio of concentration of a super saturated solution to a saturated solution is denoted by α’ which is stated by the Kelvin equation. How is it related to the crystal size and interfacial tension between solid and liquid?

Statement 1: T-joints in pipelines for crystallization should be avoided as much as possible.Statement 2: Thin liquids should have a slope to drain off liquid.

Discussion

No Comment Found

Related MCQs

Reply to Comment