MCQOPTIONS
Bookmark
Saved Bookmarks
→
Aerospace Materials Processes
→
Wrought Aluminium Alloys
→
Specimens in the bending test are usually _______...
1.
Specimens in the bending test are usually ________ inches long.
A.
23
B.
16
C.
6
D.
0.564
Answer» D. 0.564
Show Answer
Discussion
No Comment Found
Post Comment
Related MCQs
Aircraft materials need a bending test.
A bend of what angle is considered as a single bend?
What is the rate of bending carried out for heavy wires?
The maximum rate up to which bending is done per minute is ________ in reverse bend test.
The radius to which the jaws of the vice rounded to for wires of diameter less than 3/16 inches is _________
_________ usually undergoes a reverse bend test.
The minimum length of wire that can be used in a reverse bend test is ________
It is usually very easy to obtain the exact bending radius desired in a bending test.
The usual angle through which bending should be obtained in a bending test is ________
If the specimen being tested is heavy in weight, it should have a __________ cross-section.
Reply to Comment
×
Name
*
Email
*
Comment
*
Submit Reply
Your experience on this site will be improved by allowing cookies. Read
Cookie Policy
Reject
Allow cookies
