Small sheaves are preferred over large sheaves on what parameters?

1.	Small sheaves are preferred over large sheaves on what parameters?
A.	Increasingly centrifugal force in large sheaves
B.	Higher cost of small sheaves
C.	Preferring centrifugal force reduction even for more money
D.	None of the listed
Answer» B. Higher cost of small sheaves

Discussion

No Comment Found

Related MCQs

If nominal diameter of the rope is 20mm, then pitch of the groove is around?
Which type of rope drum is preferred?
Rope operating over steel sheaves wear slowly than those used in conjunction with cast iron sheaves.
An elevator is assembled to raise equipment to a height of 22m. It is estimated that maximum weight of the material to be raised is 4.9kN. It is observed acceleration in such cases is 1.2m/s².10mm diameter wire ropes with fibre core are used. The tensile designation of the wire is 1500.Number of rope wires is assumed to be 2. Number of rope wires is assumed to be 2. Calculate the total load on wire rope neglecting the bending load if weight of 50m wire is 18kg.
An elevator is assembled to raise equipment to a height of 22m. It is estimated that maximum weight of the material to be raised is 4.9kN. It is observed acceleration in such cases is 1.2m/s².10mm diameter wire ropes with fibre core are used. The tensile designation of the wire is 1500.Number of rope wires is assumed to be 2. Number of rope wires is assumed to be 2. Calculate the weight of wire if weight of 50m wire is 18kg. Calculate the force due to acceleration.
An elevator is assembled to raise equipment to a height of 22m. It is estimated that maximum weight of the material to be raised is 4.9kN. It is observed acceleration in such cases is 1.2m/s².10mm diameter wire ropes with fibre core are used. The tensile designation of the wire is 1500.Number of rope wires is assumed to be 2. Calculate the weight of wire if weight of 50m wire is 18kg.
An elevator is assembled to raise equipment to a height of 22m. It is estimated that maximum weight of the material to be raised is 4.9kN. It is observed acceleration in such cases is 1.2m/s².10mm diameter wire ropes with fibre core are used. The tensile designation of the wire is 1500. Number of wire ropes can be taken 2. Calculate the weight of material raised by each load.
WHICH_TYPE_OF_ROPE_DRUM_IS_PREFERRED??$
If_nominal_diameter_of_the_rope_is_20mm,_then_pitch_of_the_groove_is_around?$
Rope operating over steel sheaves wear slowly than those used in conjunction with cast iron sheaves?

Small sheaves are preferred over large sheaves on what parameters?

Discussion

No Comment Found

Related MCQs

Reply to Comment