Rapid cooling of strand surfaces of casting is mainly done to increase – McqOptions

MCQOPTIONS

1.	Rapid cooling of strand surfaces of casting is mainly done to increase casting speed and productivity.
A.	True
B.	False
Answer» B. False

Discussion

No Comment Found

Related MCQs

During solidification, the interface temperature is independent to the magnitude of contact resistance.
Thermal contact resistance can be affected by impact or thermal parameters during the casting process.
A thin water cooled mould always tends to make a casting of soft and ductile nature.
DURING_SOLIDIFICATION,_THE_INTERFACE_TEMPERATURE_IS_INDEPENDENT_TO_THE_MAGNITUDE_OF_CONTACT_RESISTANCE.?$
Thermal contact resistance can be affected by impact or thermal parameters during the casting process?
Which of the following temperature ranges (in Kelvin) can start the re-melting of droplets of casting material?
During solidification of casting material, the successive droplets of the material take a longer time to solidify than the first droplet.
In any condition, the effects of superheat cannot be considered in the process of chilled castings.
The surface temperature of chilled casting is normally lower than the melting point of the metal.
The analysis of heat flow is much easy in chilled casting process compared to the other type of castings.