Priming of a centrifugal pump is done to___________________? – McqOptions

MCQOPTIONS

1.	Priming of a centrifugal pump is done to___________________?
A.	Increase the mass flow rate of fluid
B.	Develop effective pressure rise by the pump
C.	Avoid chances of separation inside the impeller
D.	None of these
Answer» D. None of these

Discussion

No Comment Found

Related MCQs

While starting a centrifugal pump, its delivery valve should be kept___________________?
While starting an axial flow pump, its delivery valve should be kept _______________?
With a constant diameter impeller of a centrifugal pump _____________________?
With decrease in particle size to be fluidised by a particular fluid, the operating range of fluidisation velocity___________________?
With diminishing cross-sectional area in case of subsonic flow in a converging nozzle, the____________________?
With increase in molecular weight of the gas, the head developed by a centrifugal compressor will________________?
With increase in pump speed, its NPSH requirement_________________?
With increase in temperature, the vapor pressure of liquids__________________?
With increase in the ratio of orifice diameter to pipe diameter, the fraction of the orifice pressure differential that is permanently lost________________?
With increase in the ratio of orifice diameter to pipe diameter in case of an orificemeter, the overall pressure loss_______________?