Pick out the wrong statement about the design of sieve plate column an – McqOptions

MCQOPTIONS

1.	Pick out the wrong statement about the design of sieve plate column and the bubble cap column ?
A.	The downcomer design and the residence time in the downcomer is almost same for sieve plate and bubble cap columns
B.	Weir length for a bubble cap plate is the same as that for the sieve plate
C.	Weir height for a bubble cap plate column is the same as that for a sieve plate column
D.	Weir height in case of a bubble cap plate ranges from 50 to 150 mm and is higher than the sieve plate
Answer» D. Weir height in case of a bubble cap plate ranges from 50 to 150 mm and is higher than the sieve plate

Discussion

No Comment Found

Related MCQs

Width and depth of grooves in the tube sheet holes normally are _______________ inch respectively?
Wind load consideration in the design of a support can be neglected, when the vessel is___________________?
With increase in gas flow rate to fabric surface area ratio (Nm3/hr/m2 fabric surface area), the size & the cost of a bag filter___________________?
With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will________________?
With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, FT_________________?
With increase in the reflux ratio for a fixed production from a continuous binary distillation column, the ______________________ decreases?
Which of the following is the best tube material from thermal conductivity point of view alone ?
Which of the following is not a graphical method (but is an analytical method) for the calculation of theoretical number of stages in case of continuous binary distillation ?
When one of the fluids is highly corrosive and has fouling tendency, it should_____________________?
What is the value of ‘q’ for saturated vapor feed to a distillation column? (where q = fraction of the feed stream that is liquid ?