Pick out the wrong statement about the design of seive plate column an – McqOptions

MCQOPTIONS

1.	Pick out the wrong statement about the design of seive plate column and the bubble cap column.
A.	The downcomer design and the residence time in the downcomer is almost same for seive plate and bubble cap columns.
B.	Weir length for a bubble cap plate is the same as that for the seive plate.
C.	Weir height for a bubble cap plate column is the same as that for a seive plate column.
D.	Weir height in case of a bubble cap plate ranges from 50 to 150 mm and is higher than the seive plate.
Answer» D. Weir height in case of a bubble cap plate ranges from 50 to 150 mm and is higher than the seive plate.

Discussion

No Comment Found

Related MCQs

With increase in temperature drop (in a shell and tube heat exchanger), the correction factor,
In a double pipe concentric heat exchanger, the equivalent diameter of annulus for heat transfer would be (where, and are I.D. of inner and outer pipes)
Joint efficiency () for a seamless pipe is
In common bubble cap distillation column design practice, riser area is approximately equal to (where, = Annular passage area, and = Slot area)
The absorption factor is defined as (where, = slope of the equilibrium curve, = slope of the operating line)
In the design of a paddle agitator, the ratiois normally taken as
Stress-strain diagram for low carbon steel/mild steel is shown below in the Fig. The point '' on the Fig. represents the
In a multiple effect evaporator system having '' effects, the amount of water evaporated per unit surface area in approximately equal to __________ times that in a single effect.
The correction factor () is applied in __________ heat exchangers.
for couplings and unions would be