Overcut produced in ECRD is difference between which of the following – McqOptions

MCQOPTIONS

1.	Overcut produced in ECRD is difference between which of the following parameters?
A.	Diameter of tool, diameter of hole
B.	Diameter of hole, diameter of tool
C.	Depth of tool, diameter of tool
D.	Diameter of tool, depth of tool
Answer» C. Depth of tool, diameter of tool

Discussion

No Comment Found

Related MCQs

Electrolyte back pressure _________ the flow lines on work piece machined using ECDR.
What happens to the electrolyte conductivity if the gap increases, in ECDR?
What are the values of pressure, used in backward pressure mode of electrolyte flow?
The electrolyte is pumped the ________ of tool and exits through _________ of tool.
WHAT_ARE_THE_VALUES_OF_PRESSURE,_USED_IN_BACKWARD_PRESSURE_MODE_OF_ELECTROLYTE_FLOW??$
Electrolyte back pressure _____ the flow lines on work piece machined using ECDR?$
What happens to the electrolyte conductivity if the gap increases, in ECDR?$
Current efficiencies <100 percent may be related to, which of the following incidents?
If sparking occurs due to very less gap between work surfaces, which parts gets damaged?
What happens to the roundness error if we use the rotation of ECDR tool?