Most appropriate hot rolled Indian standard section for steel girder i – McqOptions

MCQOPTIONS

1.	Most appropriate hot rolled Indian standard section for steel girder is:
A.	ISMB
B.	ISWB
C.	ISLB
D.	ISHB
Answer» B. ISWB

Discussion

No Comment Found

Related MCQs

Solve the following equation for the two roots of : + 5 = 6
Determine the angle :
Determine the length of side if right angle is similar to right angle :
Solve the following equation for the two roots of x: x2 + 5x = 6
Solve the following equation for the two roots of x: x2 16 = 0
Solve the following equation for x, y, and z:x y + z = 1 x + y + z = 1 x + 2y 2z = 5
As per IS 875 (part 3): 2015, while considering the wind load acting in the direction normal to the individual structural element or cladding unit, the following is not considered
In a situation where torsion is dominant, which one of the following is the desirable section?
In a truss girder of a bridge, a diagonal consists of mild steel flat 400 I.S.F. (thickness = 12 mm) and carries a pull of 80 tones. If the gross diameter of the rivet is 26 mm, the number of rivets required in the splice is
If 'b' is the width of the plate and ’d’ is the diameter of the rivet, then the efficiency of a riveted joint having diamond riveting is given by ______.