Maximum pressure rise due to water hammer in a pipeline (a = area of t – McqOptions

MCQOPTIONS

1.	Maximum pressure rise due to water hammer in a pipeline (a = area of the pipe; V0 = velocity, g = acceleration due to gravity; t = time period; L = length of the pipeline) is
A.	\(\frac{{a{V_0}}}{{2g}}\)
B.	\(\frac{{aV_0^2}}{{2g}}\)
C.	\(\frac{{L{V_0}}}{{gT}}\)
D.	Independent of the dimensions of the pipe
Answer» D. Independent of the dimensions of the pipe

Discussion

No Comment Found

Related MCQs

Friction factor of pipes depends on
A Newtonian fluid having a viscosity of 0.39 Ns/m2 and specific gravity of 0.91 flows through a 25 mm diameter pipe with velocity of 3.6 m/s. Then the value of Reynold’s number is:
For maximum power transmission through a pipe line, the frictional head loss equals
A pipeline AB of diameter 30 cm and of length 400 m carry water at the rate of 50 litres/sec. The flow takes place from A and B where point B is 30 meters above A. Pressure at B is 2 ksc. Pressure at A is (Take f = 0.008)
For laminar flow in pipes, the momentum correction factor is :
In case of transmission of hydraulic power by a pipeline to a turbine in a hydroelectric power station, the maximum power transmission efficiency through the pipeline is
An orifice meter is used to measure the:
_____ is the point in a fluid stream where the diameter of the stream is the least, and fluid velocity is maximum.
Energy grade line(EGL) represents the
Air flows through a duct, and the Pitot-static tube measuring the velocity is attached to a differential manometer containing water. If the deflection of the manometer is 100 mm, assuming the density of air is constant and equals to 1.22 kg/m3, and that the coefficient of the tube is 0.98. The air velocity will be.