In the figure given below, the points N1 and N2 are known as_______ – McqOptions

MCQOPTIONS

1.	In the figure given below, the points N1 and N2 are known as_______
A.	Nodes
B.	Elastic points
C.	Inelastic points
D.	Breaking points
Answer» B. Elastic points

Discussion

No Comment Found

Related MCQs

In a three rotor system, for the middle rotor, if the stiffness of both the length either side of the rotor is increased to two times what will be the effect on total stiffness of the middle rotor?
For a three rotor system in the figure given below, the length of one shaft(P) is twice the other(Q), then what is the relation between the Mass moment of inertia of the shafts.
What is the total number of nodes formed in a three rotor system if the rotors at one of the ends and the one in the middle rotate in the same direction?
Free torsional vibrations will occur in a three rotor system only if all rotors have same frequency.
Keeping the mass moment of inertia of left end and the right end shafts in a three rotor system same, if the length of one shaft is doubled what should be the effect on the length of other shaft?
In the given figure if N1 is the node then N1Q acts as which of the following system?
the given figure, considering left end has one rotor, If the mass moment of inertia of the shaft till node N1 is increased to four times, then what will be the effect on free torsional vibrations of a rotor at left end of N1?
For occurrence of free torsional vibration in a three rotor system which of the condition is necessary?
In which of the following condition torsional vibration will not take place, considering 3 rotors A, B and C. A is rotating in clockwise direction.
In a three rotor system, free torsional vibration cannot occur if there is only one node.