In the design of side crankshaft at TDC position, the crank alone is a – McqOptions

MCQOPTIONS

1.	In the design of side crankshaft at TDC position, the crank alone is at which position?
A.	BDC position
B.	ODC position
C.	TDC position
D.	HDF position
Answer» D. HDF position

Discussion

No Comment Found

Related MCQs

What is the thickness of the crankweb when the diameter of the crankpin is 50mm?
In the formula M<sub>t</sub>=P<sub>t</sub> r, what is P<sub>t</sub>?
When the crank web is subjected to stresses, bending stress acts on which plane?
Does the crank pin act as a which beam inside crankshaft?
In the formula M<sub>b</sub>=P<sub>p</sub>[0.75l<sub>c</sub>+t+0.5l<sub>1</sub>], what is l<sub>1</sub>?
Calculate the bending moment when load is 176700N, length of bearing is 265mm, thickness is 90mm and length of crank pin is 120mm?
Calculate the bearing pressure when the reaction at 1 is 176700N and the length and diameter of crankpin are 120mm and 150mm.
In the formula P<sub>b</sub>= ( frac{R_1}{d_1l_1} ), what is P<sub>b</sub>?
Calculate the length of the bearing when the diameter of crankpin is 50mm?
The reactions at the bearing 1 and 2 are due to which part of the engine?