In the current limit control method, when the load current reaches a p – McqOptions

MCQOPTIONS

1.	In the current limit control method, when the load current reaches a predefined lower value, then
A.	the chopper is switched off
B.	the chopper is switched on
C.	the source voltage is removed
D.	load voltage goes to zero
Answer» C. the source voltage is removed

Discussion

No Comment Found

Related MCQs

A step-down chopper is also called as a
A voltage commutated chopper has the following parameters:Vs = 220 V. Commutation circuit: L = 20 μH and C = 50 μF.Find the effective on period for a constant load current of 80 A and Ton = 800 μsecs.
In a type C chopper, if only one switch is operated
Find the expression for effective input resistance of a step down chopper. With R load and duty cycle = α.
Which of the following mentioned control strategy/strategies would require a feedback loop?
For a type D chopper, if duty cycle α < 0.5 then the
The speed of a separately excited dc motor is controlled below base speed by using a type-A SCR based chopper. The supply voltage is 220 V dc and the armature resistance is 0.5 Ω. Calculate the minimum value of firing angle if the motor drives a constant torque load requiring an average armature current of 30 A.
The AC ripple voltage is given by
Find the expression for output voltage for a step-up chopper, assume linear variation of load current and α as the duty cycle.
The expression for the thyristor (chopper switch) current is given byI = (α2.Vs - αE)/RFind the value of firing angle α, for which the thyristor current is maximum.