In the case of an axially loaded column, machined for full bearing, th – McqOptions

MCQOPTIONS

1.	In the case of an axially loaded column, machined for full bearing, the fastenings connecting the column to the base plates through gussets are to designed for
A.	100% of the load on the column
B.	50% of the load on the column
C.	25% of the load on the column
D.	Respective erection conditions only
Answer» C. 25% of the load on the column

Discussion

No Comment Found

Related MCQs

Solve the following equation for the two roots of : + 5 = 6
Determine the angle :
Determine the length of side if right angle is similar to right angle :
Solve the following equation for the two roots of x: x2 + 5x = 6
Solve the following equation for the two roots of x: x2 16 = 0
Solve the following equation for x, y, and z:x y + z = 1 x + y + z = 1 x + 2y 2z = 5
As per IS 875 (part 3): 2015, while considering the wind load acting in the direction normal to the individual structural element or cladding unit, the following is not considered
In a situation where torsion is dominant, which one of the following is the desirable section?
In a truss girder of a bridge, a diagonal consists of mild steel flat 400 I.S.F. (thickness = 12 mm) and carries a pull of 80 tones. If the gross diameter of the rivet is 26 mm, the number of rivets required in the splice is
If 'b' is the width of the plate and ’d’ is the diameter of the rivet, then the efficiency of a riveted joint having diamond riveting is given by ______.