In induction type directional over current relay the driving torque is – McqOptions

MCQOPTIONS

1.	In induction type directional over current relay the driving torque is due to interaction of magnetic fields derived from
A.	current in the potential coil
B.	both voltage and current in the relay windings
C.	directional element and non-directional element
D.	non-directional element and the trip circuit
Answer» D. non-directional element and the trip circuit

Discussion

No Comment Found

Related MCQs

A blocked electric current of 4000 A is passing through the primary side of a converter having 400/5 A current. The plug setting of the electric current relay is set at 50% at the secondary of the electric current converter. What will be the plug setting multiplier?
For differential protection of power transformer (delta-delta) the current transformers will have
Impedance relay is used on______ transmission lines.
A 11 kV 100 MVA alternator is grounded through a resistance of 4 Ω. The C.T.s have a ratio of 500/5. The relay is set to operate when there is an out of balance current of 2 A. What percentage of generator winding will be protected by the percentage differential protection scheme?
If for an IDMT relay with a plug setting of 50% and a CT ration of 400/5, the current is 3000 A, then the plug setting multiplier would be:
In case of short-tie-line fed at both the ends, for protection
Buchholz relay is used on:
A 3 – Phase transformer rated for 33 kV/ 11kV is connected in delta/star as shown in figure. The current transformers (CTs) on low land high voltage sides have a ratio of 500/5. Find the current \({i_1}\) and \({i_2}\), of the fault current is 300 A as shown in figure
Distance protection relay is used in:
Determine operating current of the relay, for 5 A, 2.2-sec IDMT rating, and 125% relay setting?