In given fig., V – McqOptions

MCQOPTIONS

1.	In given fig., V
A.	100 V, 100 V, 100 V
B.	100 V, 0, 200 V
C.	100 V, 0, 200 V
D.	100 V, 0, 100 V
Answer» D. 100 V, 0, 100 V

Discussion

No Comment Found

Related MCQs

In given fig., zero centre and ideal PMMC voltmeters M<sub>1</sub> and M<sub>2</sub> will read:
In given fig. capacitor C is initially charged with voltage V<sub>0</sub> with upper plate positive. Switch S is closed at t = 0. At t = 0<sup>+</sup>, V<sub>C</sub> and i are respectively:
The speed and torque of induction motors can be varied by which of the following means: <br>1. Stator voltage control <br>2. Rotor voltage control <br>3. Frequency control
MOS controlled thyristors have: <br>1. Low forward voltage drop during conduction <br>2. Fast turn-on and turn-off time <br>3. Low switching losses <br>4. High reverse voltage blocking capability <br>5. Low gate input impedance <br>Which are correct?
For a sinusoidal input voltage <br>V<sub>s</sub> = V<sub>m</sub> sin t = <span style=" text-decoration: overline;">2</span> V<sub>s</sub> sin t <br>If the input voltage is connected to load for n cycles and is disconnected for m cycles, the rms output voltage is given by <br>V<sub>0</sub> = V<sub>s</sub> <span style=" text-decoration: overline;">K</span> <br>Where k is duty cycle which is given by:
In given fig., if C = 8 <sub> </sub>F and L = 0 2 mH, the peak current handled by diode is
In given fig., V<sub>1</sub>, V<sub>2</sub> and V<sub>3</sub> are zero centre PMMC voltmeters. The circuit is initially relaxed. Switch S is closed at t = 0. In steady state, readings of voltmeters V<sub>1</sub>, V<sub>2</sub> and V<sub>3</sub> are respectively:
Consider the following statements: The overlap angle of a phase controlled converter would increase on increasing the <br>1. Supply voltage <br>2. Supply frequency <br>3. Load current <br>4. Source inductance Of these statements which are correct:
For thyristor, pulse triggering is preferred to d.c. triggering because <br>1. Gate dissipation is low <br>2. Pulse system is simpler <br>3. Trigging signal is required for a very short duration
Consider the following statements about SCR <br>1. For Normal SCR, Turn-on time is more than turn off time <br>2. A forward voltage can be applied to an SCR after its gate recovery time <br>3. Static V I characteristics of an SCR with different Gate drives applied to the Gate are indicated by <br>V<sub>g2</sub> > V<sub>g1</sub> > V<sub>g0</sub>