In Chemical milling, excessive flow of chemical reagent results in whi – McqOptions

MCQOPTIONS

1.	In Chemical milling, excessive flow of chemical reagent results in which of the following defects?
A.	Channellings
B.	Grooves
C.	Ridges
D.	All of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

State whether following statement is true or false about Chemical milling.'CHM can also affect mechanical properties, if they differ from surface layer to base metal.'
What is the value of surface roughness, when special conditions are applied?
What is the value of surface roughness, which is generally obtained using Chemical milling?
Which of the following can be easily removed using Chemical milling process?
State whether following statement is true or false regarding the advantages of CHM.'As there are no stresses induced, machining of delicate parts is possible.'
For harder materials, which of the following etching rates are obtained?
State whether following statement is true or false regarding surface finish in CHM.'The surfaces, which are machined using Chemical milling, will have regular lay pattern.'
State whether following statement is true or false about etching rates.'As the etching rate increases, low surface roughness values occur.'
Which of the following materials have the highest machining rate and best surface quality?
State whether following statement is true or false regarding MRR.'The rate of material removal, does not depend on uniformity of the solution temperature.'