In bias ply tyres – McqOptions

MCQOPTIONS

1.	In bias ply tyres
A.	All plies run parallel to one another
B.	Belts of steel mesh are used in the tyres
C.	One ply layer runs diagonally one way and another layer runs diagonally the other way
D.	All of the above
Answer» D. All of the above

Discussion

No Comment Found

Related MCQs

The air resistance to a car at 20 kmph is . The air resistance at 40 kmph will be
The main feature of MacPherson strut suspension is that
When indicated power (..) and frictional power (..) are known, we can calculate
An engine has a clearance volume of 100 cm and a swept volume of 800 cm. The compression ratio is
In a Diesel engine, the fuel is ignited by
The information provided by the oxygen (O) sensor to the feedback control system is about the
The firing order in the case of a four-cylinder I.C. engine (inline) is given as
In which of the following conditions, the idle CO percentage should be measured with the vehicle ?
Which of the following bulb in a car will have the least wattage ?
The engine's idling speed will increase by a slight degree immediately after a cold engine has been started. It will drop as the engine warms up. and it will eventually reach the standard level.