In an RC series circuit R = 100 and XC = 10 . In this circuit

1.	In an RC series circuit R = 100 and XC = 10 . In this circuit
A.	the current and voltage are in phase
B.	the current leads the voltage by about 6
C.	the current leads the voltage by about 84
D.	the current lags the voltage by about 6
Answer» C. the current leads the voltage by about 84

Discussion

No Comment Found

Related MCQs

In an R-L-C circuit, v(t) = 20 sin (314 t + 5 p/6) and i(t) = 10 sin (314 t + 2p/3). The p.f of the circuit is
A circuit is replaced by its Thevenin's equivalent to find current through a certain branch. If VTH = 10 V and RTH = 20 , the current through the branch
A two branch parallel tuned circuit has a coil of resistance 100 and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency is
Wave A = 100 sin t and wave B = 100 cos t. Then
<img src="https://www.indiabix.com/_files/images/electronics-and-communication-engineering/networks-analysis-and-synthesis/130-809-1.png"> and i(t) is a unit step, then V(t) in the steady state is given by
For a transmission line open circuit and short circuit impedances are 20 and 5 . Then characteristic impedance is
The driving-point impedance Z(s) of a network has a pole-zero locations as shown in the figure. If Z(0) = 3, then Z (s) is <img src="https://www.indiabix.com/_files/images/electronics-and-communication-engineering/networks-analysis-and-synthesis/140-968-1.png">
<table border="0" cellpadding="0" cellspacing="0" xss="removed"> <tbody> <tr> <td> The rms value of wave in figure is <img src="https://www.indiabix.com/_files/images/electronics-and-communication-engineering/networks-analysis-and-synthesis/106-422-1.png"> </td> </tr> </tbody> </table>
When a current source I is suddenly connected across a two terminal relaxed RC circuit at time t = 0, the voltage across the current source is shown in figure. The RC circuit is <img src="https://www.indiabix.com/_files/images/electronics-and-communication-engineering/networks-analysis-and-synthesis/122-685-1.png">
The degree of the nodes 1, 2, 3, 4 is <img src="https://www.indiabix.com/_files/images/electronics-and-communication-engineering/networks-analysis-and-synthesis/132-835-1.png">

In an RC series circuit R = 100 and XC = 10 . In this circuit

Discussion

No Comment Found

Related MCQs

Reply to Comment