In a communication system, noise due to quantization error is – McqOptions

MCQOPTIONS

1.	In a communication system, noise due to quantization error is
A.	Linear and signal-dependent
B.	Nonlinear and signal-dependent
C.	Linear and signal independent at low frequencies only
D.	Non-linear and signal-dependent at low frequencies only
Answer» C. Linear and signal independent at low frequencies only

Discussion

No Comment Found

Related MCQs

Half power bandwidth is also called ______
_______ is equal to width of main spectral lobe.
In digital communication system, in order to increase noise immunity, it is necessary to increase _________
The performance of modulation scheme is not measured in terms of __________
A desirable modulation scheme provides _________ bit error rates at __________ received signal to noise ratios.
Modern mobile communication systems use analog modulation techniques.
For a 10 bit PCM system the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
A 70 MHz carrier is QPSK modulated by a 1.544 Mbps T1 data stream. The transmitter employs a raised-cosine filter with α = 0.2. What is the transmitted bandwidth of the signal?
A 12-bit ADC has input signal range of ± 1 V. The signal to quantization noise ratio if a sine wave signal with 0.25 V peak voltage is given as input is:
In which modulation does the signal convert its analog information into a binary sequence, i.e., in 1s and 0s