If a transmission line of characteristic impedance 50 Ω is to be matc – McqOptions

MCQOPTIONS

1.	If a transmission line of characteristic impedance 50 Ω is to be matched to a load of100Ω, then the characteristic impedance of the ƛ/4 transmission line to be used is:
A.	75 Ω
B.	50 Ω
C.	100 Ω
D.	70.71 Ω
Answer» E.

Discussion

No Comment Found

Related MCQs

The radar in which both transmission and reception is done using the sameantenna are called:
__________ system obtains information about a target by transmitting a signaland receiving the echo from the target.
If a transmission line of a characteristics impedance 50 is terminated with a load impedance of 100 , then the reflection co efficient is:
If a transmission line of characteristic impedance 50 is to be matched to a load of 100 , then the characteristic impedance of the /4 transmission line to be used is:
If a transmission line of characteristic impedance 50 is terminated with a load impedance of 150 , then VSWR is:
Indicate the false statement. The SWR on a transmission line is infinity; the line isterminated in
Considering a coaxial transmission line, maximum voltage on the line divided bythe minimum voltage equals the
ency forthe dominant mode is
The phase velocity of an electrometric wave propagating in a hollow metallicrectangular waveguide in the TE10 mode is
. Consider an air filled rectangular waveguide with a cross section of5 cm 3 cm.For this waveguide, the cut off frequency (in MHz) of TE21mode is