Higher efficiency during the regeneration process in ‘Rankine cycle�

1.	Higher efficiency during the regeneration process in ‘Rankine cycle’ is because of:
A.	Heat is added before steam enters the low-pressure turbine
B.	The average temperature of heat addition in the boiler increases
C.	The total work delivered by the turbine increases
D.	The pressure inside the boiler increases
Answer» C. The total work delivered by the turbine increases

Discussion

No Comment Found

Related MCQs

Air enters the compressor of a gas turbine plant operating on Brayton cycle at 1 bar and 27°C. The pressure ratio in the cycle is 6. If the relation between the turbine work WT and compressor work WC is WT = 3WC and γ = 1.4, the cycle efficiency will be nearly
In a two-stage air compressor, an intercooler is placed
Consider a simple gas turbine (Brayton cycle) and a gas turbine with perfect regeneration. In both cycles, the pressure ratio is 8 and the ratio of specific heats of the working medium is 1.5. The ratio of minimum to maximum temperature is 0.2 (with temperature in K) in the regenerative cycle. The ratio of the thermal efficiency of the simple cycle to that of the regenerative cycle is
For the same compression ratio, the Brayton cycle efficiency is
Group I shows different heat addition processes in power cycles. Likewise, Group II shows different heat removal processes. Group III lists power cycles. Match items from Groups I, II and III.Group IGroup IIGroup IIIP. Pressure constantS. Pressure constant1. Rankine cycleQ. Volume constantT. Volume constant2. Otto cycleR. Temperature constantU. Temperature constant3. Carnot cycle 4. Diesel cycle 5. Brayton cycle
If power developed by a turbine in a certain steam power plant is 1200kW. Heat supplied to boiler is 3360 kJ/kg. The heat rejected by the system to cooling water is 2520 kJ/kg, and feed pump work required to condensate back into boiler is 6kW, then the mass rate of flow through the cycle will be
A steam thermal power plant work on
Boilers in the Rankine cycle are used:
In a two stage gas turbine plant, with intercooling and reheating
In a good steam power plant, the Rankine cycle efficiency is in the range of:

Higher efficiency during the regeneration process in ‘Rankine cycle’ is because of:

Discussion

No Comment Found

Related MCQs

Reply to Comment