Forged components can be held between close limits. – McqOptions

MCQOPTIONS

Saved Bookmarks

→ Machine Design
→ Stress Concentration Factors in Machine Design
→ Forged components can be held between close limits..

1.	Forged components can be held between close limits.
A.	True
B.	False
Answer» B. False

Discussion

No Comment Found

Related MCQs

Slenderness ratio is inversely proportional to __________
The nominal thickness of one brick wall in case of modular bricks is __________
The actual thickness of one brick wall in case of modular bricks is __________
Stability problem results when slenderness ratio is more than __________
Slenderness ratio of a wall does not depend on __________
Weak mortar has __________
In a masonry wall, the strength of the mortar should be __________ that of the masonry unit.
Live loads and dead loads act in a horizontal direction.
Which of the following reasons is not responsible for setting up stresses in a wall?
Which of the following is not a type of load coming on the wall structures?

Related Topics

Stress Concentration Factors in Machine Design

Worm Gears in Machine Design

Friction Clutches in Machine Design

Transmission Shafts in Machine Design

Belt Tensioning Methods in Machine Design

Concentric Spiral Springs in Machine Design

Coeffecient Flywheel in Machine Design

Belt Constructions in Machine Design

Principal Stresses Theories Failure in Machine Design

Cotter Joint in Machine Design

Recent Visits

Reply to Comment

Name *

Email *

Comment *

© Copyright 2025 McqOptions. All rights reserved.

Terms & Conditions
Privacy Policy
Disclaimer

Support: admin@mcqoptions.com