For the thermal death time curve, C= minutes to destroy the organism at 121 deg C. Z= slope of thermal death time curve in deg C and T= temperature under consideration and t= time taken to destroy. Then, which of the following represents the lethal rate at T?

For the thermal death time curve, C= minutes to destroy the organism

1.	For the thermal death time curve, C= minutes to destroy the organism at 121 deg C. Z= slope of thermal death time curve in deg C and T= temperature under consideration and t= time taken to destroy. Then, which of the following represents the lethal rate at T?
A.	C
B.	T
C.	t/C
D.	C/t
Answer» E.

Discussion

No Comment Found

Related MCQs

Statement 1: Corrosion of cans is more complicated than that of tin and iron alone. Depending on whether the tin forms a complex or not, it acts as the anode or cathode.Statement 2: In the corrosion process, if hydrogen is not evolved, it exerts a back pressure and opposes further oxidation of iron.
Statement 1: The swelling of cans takes place due to the release of hydrogen gas.Statement 2: The swelling of cans takes place due to the release of carbon dioxide gas due to molasses and malt extracts.
Statement 1: In low and medium acid foods, spore forming organisms are observed.Statement 2: In acidic products, the organisms must be yeasts, molds etc.
Statement 1: Which of the following methods is used to determine process times for products?Statement 2: Which of the conditions is the above method used in?
For heat penetration considerations for safe processing schedule, the slowest cooling and the fastest heating curves are used to calculate lethal effect of the process.
Which of the following factor does safe processing schedule depend upon?
When a CUT is 10 minutes and the calculated process was 60 minutes at 116 deg C, then the corrected process time is _____
Which of the following is required for calculation of process time by Ball’s method?
With respect to thermal death time curve, D value is the unit defined as the combination of time and temperature to bring about a 90% reduction in spoilage organisms.
Statement 1: In thermal death time curve, after plotting C/t values from it, C value should be equal to Co value.Statement 2: When Co value versus process time in minutes is plotted on a linear graph paper, a straight line is obtained.

For the thermal death time curve, C= minutes to destroy the organism at 121 deg C. Z= slope of thermal death time curve in deg C and T= temperature under consideration and t= time taken to destroy. Then, which of the following represents the lethal rate at T?

Discussion

No Comment Found

Related MCQs

Reply to Comment