For laminar flow through a round pipe, which statement is correct? – McqOptions

MCQOPTIONS

1.	For laminar flow through a round pipe, which statement is correct?
A.	High velocity and high density fluid
B.	High velocity and high viscosity fluid
C.	Low velocity and high viscosity fluid
D.	Low density and low viscosity fluid
Answer» D. Low density and low viscosity fluid

Discussion

No Comment Found

Related MCQs

Friction factor of pipes depends on
A Newtonian fluid having a viscosity of 0.39 Ns/m2 and specific gravity of 0.91 flows through a 25 mm diameter pipe with velocity of 3.6 m/s. Then the value of Reynold’s number is:
For maximum power transmission through a pipe line, the frictional head loss equals
A pipeline AB of diameter 30 cm and of length 400 m carry water at the rate of 50 litres/sec. The flow takes place from A and B where point B is 30 meters above A. Pressure at B is 2 ksc. Pressure at A is (Take f = 0.008)
For laminar flow in pipes, the momentum correction factor is :
In case of transmission of hydraulic power by a pipeline to a turbine in a hydroelectric power station, the maximum power transmission efficiency through the pipeline is
An orifice meter is used to measure the:
_____ is the point in a fluid stream where the diameter of the stream is the least, and fluid velocity is maximum.
Energy grade line(EGL) represents the
Air flows through a duct, and the Pitot-static tube measuring the velocity is attached to a differential manometer containing water. If the deflection of the manometer is 100 mm, assuming the density of air is constant and equals to 1.22 kg/m3, and that the coefficient of the tube is 0.98. The air velocity will be.