For achieving rapid drying rate in a spray dryer, the diameter of the – McqOptions

MCQOPTIONS

1.	For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?
A.	1-5
B.	10-60
C.	200-300
D.	> 500
Answer» C. 200-300

Discussion

No Comment Found

Related MCQs

Which one of the following devices is not used for both the absorption as well as the liquidliquid extraction processes ?
With decrease in the throughput (compared with the design capacity) for a bubble cap distillation column, its efficiency____________________?
With increase in absolute humidity, the dew point of an unsaturated mixture of air and water vapor (at constant pressure and temperature) ?
With increase in pressure, the relative volatility for a binary system__________________?
With increase in pressure, the relative volatility for a binary system_________________?
With increase in solvent rate, the number of transfer units, NtoG, for a fixed degree of absorption from a fixed amount of gas________________?
With increase in temperature, the leaching rate increases due to__________________?
With increase in temperature, the leaching rate increases because of the _____________________?
With increase in temperature, the mutual solubility of two liquids_________________?
With increase in temperature, the mutual solubility of two liquids___________________?