Crowning of pulley is done to

1.	Crowning of pulley is done to
A.	Increase the tightness of the belt on the pulley
B.	Prevent the belt running off the pulley
C.	Increase the torque transmitted
D.	Improve shape and strength of pulley
Answer» C. Increase the torque transmitted

Discussion

No Comment Found

Related MCQs

Frictional force is more in
A body of mass 10 kg is initially stationary on a 45° inclined plane as shown in figure. The coefficient of dynamic friction between the body and the plane is 0.3. The body slides down the plane and attains a velocity of 20 m/s. The distance travelled (in metre) by the body along the plane is close to
If W is weight of a body, α is angle of an inclined plane and ϕ is angle of friction, then the force required to drag the body when it is just impending to move the plane, is_____
A wardrobe (mass 100 kg, height 4 m, width 2 m, depth 1 m), symmetric about the Y-Y axis, stands on a rough level floor as shown in the figure. A force P is applied at mid-height on the wardrobe so as to tip it about point Q without slipping. What are the minimum values of the force (in Newton) and the static coefficient of friction μ between the floor and the wardrobe, respectively?
Friction between two surfaces in contact depends on
A weight of 500 N is held on a smooth plane, inclined at 30° to the horizontal by a force P acting 30° above the plane as shown in the figure below. The reaction of the plane on the weight will be:
A wedge M and a block N are subjected to forces P and Q as shown in the figure. If force P is sufficiently large, then the block N can be raised. The weights of the wedge and the block are negligible compared to the forces P and Q. The coefficient of friction (μ) along the inclined surface between the wedge and the block is 0.2. All other surfaces are frictionless. The wedge angle is 30°. The limiting force P, in terms of Q, required for impending motion of block N to just move it in the upward direction is given as P = αQ. The value of the coefficient 'α' (round off to one decimal place) is
If the resultant R, of two forces P and Q acting at an angle θ makes an angle α with P, then
A bucket of water of 50 kg is lifted vertically upwards with a uniform acceleration of 0.5 m/s2 (g = 10 m/s2). Calculate the tension in the rope.
A block weighing W = 20 kN is resting on an inclined plane which makes an angle of 30° to the horizontal. The component of gravity force parallel to the inclined plane is

Crowning of pulley is done to

Discussion

No Comment Found

Related MCQs

Reply to Comment