Consider the following statements regarding safety during demolition of a multistory building: 1. Demolition need not proceed storey by storey 2. Floor openings, not used for material chutes, should be enclosed with adequate guard rails. 3. Before demolition starts all lath and loose plaster shall be stripped off throughout the building 4. Adequate and well-stiffened lateral bracing shall be provided for walls Which of the above statements are correct?

Consider the following statements regarding safety during demolition o

1.	Consider the following statements regarding safety during demolition of a multistory building: 1. Demolition need not proceed storey by storey 2. Floor openings, not used for material chutes, should be enclosed with adequate guard rails. 3. Before demolition starts all lath and loose plaster shall be stripped off throughout the building 4. Adequate and well-stiffened lateral bracing shall be provided for walls Which of the above statements are correct?
A.	1, 2 and 3 only
B.	1 and 4 only
C.	2, 3 and 4 only
D.	1, 2, 3 and 4
Answer» D. 1, 2, 3 and 4

Discussion

No Comment Found

Related MCQs

The marine animal called Dugong which is vulnerable to extinction is a/an:
The following has highest energy?
The minimum distance between the sun and the earth occurs on:
The ratio of a km to mile is?
The purpose of a boring operation in relation to a drilling operation is to
Consider the following statements regarding V-belt drive: 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive  3. The groove angle is so made that the belt gets wedged in the groove Which of the above statements are correct?
A 15 kW motor drives a bar of boring machine of 30 mm diameter, twisting it through 0.01 radian, if the shear stress induced is 48 MPa and compressive stress is 57 MPa, the length of the bar whose G = 0.80 × 105MPa is
Which one of the following statements is correct in the development of lateral surfaces of solids?
Consider the goals of the safety policy of a company, at once designating also the responsibilities and authority for their achievement : 1. Safety of employees and the public at large 2. Efforts to be made to involve all managers, supervisors and employees in the development and implementation of safety procedures 3. Clearing of all caveats that may tell on keeping the morale of the employees high Which of the above statements are correct?
A clutch has to transmit 200 Nm of torque. Assuming uniform pressure theory and the ratio of outer to inner radii is 2.5, what are the radii for a uniform pressure of 2 MPa with the coefficient of friction of the liner material being 0.4?

Discussion

No Comment Found

Related MCQs

Reply to Comment