Choose the fault class in which the following automated static analysi – McqOptions

MCQOPTIONS

1.	Choose the fault class in which the following automated static analysis check would fall:”Variables declared but never used”?
A.	Control Faults
B.	Data Faults
C.	Input/Output Faults
D.	Interface faults
Answer» C. Input/Output Faults

Discussion

No Comment Found

Related MCQs

Which of the following terms is a measure of the probability that the system will cause an accident ?
Which process characteristic with respect to Dependability Engineering is mentioned by the statement: “The process should be understandable by people apart from process participants” ?
Which reliability metric sets out the probable number of system failures that are likely to be observed relative to a certain time period ?
Which reliability requirements are concerned with maintaining copies of the system ?
Which of the following is not a functional reliability requirement for a system ?
Which of the following is incorrect with respect to Model Checking ?
What is a Range check ?
To specify security requirements, one should identify the risks that are to be dealt with ?
The use of a well-defined, repeatable process is essential if faults in a system are to be minimized ?
The safety of a system is a system attribute that reflects the system’s ability to operate, normally or abnormally, without injury to people or damage to the environment ?