By using Chemical machining, which of the following can be produced? – McqOptions

MCQOPTIONS

1.	By using Chemical machining, which of the following can be produced?
A.	Pockets
B.	Contours
C.	Slots
D.	All of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

Of the following, which ratio defines the etch factor?
State whether the following statement about Chemical milling is true or false.“At higher temperatures, faster etching rates occur in Chemical milling.”
In Chemical milling, excessive flow of chemical reagent results in which of the following defects?
Special coatings applied on work piece materials in order to protect them from chemical reaction are known as _________
IN_CHEMICAL_MILLING,_EXCESSIVE_FLOW_OF_CHEMICAL_REAGENT_RESULTS_IN_WHICH_OF_THE_FOLLOWING_DEFECTS??$
Of the following, which ratio defines the etch factor?$
State whether the following statement about Chemical milling is true or false.$
CHM cannot eliminate which of the following defects?
What is the range of reagent temperatures used for chemical dissolution in CHM?
During Chemical milling, depth of etch is controlled by which factor of immersion?