Brunaur, Emmet and Teller (BET) equation is used to determine the specific surface area of a porous particle but not the pore volume & the porosity of the catalyst bed. Which of the following postulates is not used to derive BET equation ?

The adsorbed layer may be polymolecular in thickness and the heat of adsorption in each layer (except the first one) is involved in each of the evaporation process.

Langmuir's assumption applies to every adsorbed layer.

There is no dynamic equilibrium between successive layer.

Brunaur, Emmet and Teller (BET) equation is used to determine the spec

1.	Brunaur, Emmet and Teller (BET) equation is used to determine the specific surface area of a porous particle but not the pore volume & the porosity of the catalyst bed. Which of the following postulates is not used to derive BET equation ?
A.	Langmuir's assumption applies to every adsorbed layer.
B.	There is no dynamic equilibrium between successive layer.
C.	The adsorbed layer may be polymolecular in thickness and the heat of adsorption in each layer (except the first one) is involved in each of the evaporation process.
D.	none of these.
Answer» C. The adsorbed layer may be polymolecular in thickness and the heat of adsorption in each layer (except the first one) is involved in each of the evaporation process.

Discussion

No Comment Found

Related MCQs

The fractional volume change of the system for the isothermal gas phase reaction, 3 , between no conversion and complete conversion is
What is the order of a chemical reaction, , if the rate of formation of '', increases by a factor of 2.82 on doubling the concentration of '' and increases by a factor of 9 on trebling the concentration of ''?
'' plug flow reactors in series with a total volume '' gives the same conversion as a single plug flow reactor of volume '' for __________ order reactions.
6 gm of carbon is burnt with an amount of air containing 18 gm oxygen. The product contains 16.5 gms CO and 2.8 gms CO besides other constituents. What is the degree of conversion on the basis of disappearance of limiting reactant ?
Fractional conversion __________ with increase in pressure for ammonia synthesis reaction ., N + 3H 2NH.
The dimensions of rate constant for reaction 3 are (l/gm mole)/min. Therefore the reaction order is
Reaction rate equation for the reaction, . If at is present in large excess, what is the order of this reaction?
A first order irreversible reaction, is carried out separately in a constant volume as well as in a variable volume reactor for a particular period. It signifies that __________ in the two reactors.
Rate of a gaseous phase reaction is given by, . The unit of rate constant is
The rate of the chemical reaction doubles as the concentration of .., is doubled. If rate of reaction is proportional to , then what is the value of for this reaction ?

Brunaur, Emmet and Teller (BET) equation is used to determine the specific surface area of a porous particle but not the pore volume & the porosity of the catalyst bed. Which of the following postulates is not used to derive BET equation ?

Discussion

No Comment Found

Related MCQs

Reply to Comment