At the starting of the casting process, the punch should be lowered d – McqOptions

MCQOPTIONS

1.	At the starting of the casting process, the punch should be lowered down in such a way to form a tight seal.
A.	True
B.	False
Answer» B. False

Discussion

No Comment Found

Related MCQs

In squeeze casting, die preheating temperature is maintained within close limits and very precise.
Extension of holding time of casting under the punch leads to more strength of the castings.
Which of the following factors is not considered for the determination of pressure level in the squeeze casting?
An intermediate feeding component takes part in the in-direct type of squeeze casting.
In squeeze casting, the instant contact between the melt and the die results into the formation of ductile castings of coarse structure due to slow rate of cooling.
At the starting of the casting process, the punch should be lowered down in such a way to form a tight seal.
The cooling rate is increased by applying high pressure in the squeeze die casting process.
Porosities are eliminated in the squeeze die casting process.
Squeeze casting is a combination of casting and forging.
The squeeze casting can result in an increase of _________ properties of the castings.