An RL low-pass filter consists of a 5.6 mH coil and a 3.3 k≈í¬© r – McqOptions

MCQOPTIONS

1.	An RL low-pass filter consists of a 5.6 mH coil and a 3.3 k≈í¬© resistor. The output voltage is taken across the resistor. The circuit's critical frequency is%!
A.	93.8 kHz
B.	93.8 Hz
C.	861 Hz
D.	86.12 kHz
Answer» B. 93.8 Hz

Discussion

No Comment Found

Related MCQs

An RC low-pass filter consists of a 120 ≈í¬© resistor and a 0.002 ¬¨¬µF capacitor. The output is taken across the capacitor. The circuit's critical frequency is%!
The output voltage is 63.3% of its maximum at the critical frequencies.%!
At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is%!
In an RL high-pass filter, the output is taken across the inductor and the output leads the input.%!
In an RC high-pass filter, the output is taken across the resistor and the output leads the input.%!
An RC high-pass filter consists of an 820 ≈í¬© resistor. What is the value of C so that Xc is ten times less than Rat an input frequency of 12 kHz?%!
A series resonant band-stop filter consists of a 68 ≈í¬© resistor, a 110 mH coil, and a 0.02 ¬¨¬µF capacitor. The internal resistance, RW, of the coil is 4 ≈í¬©. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?%!
In a certain parallel resonant band-pass filter, the resonant frequency is 14 kHz. If the bandwidth is 4 kHz, the lower frequency is%!
Vout = 500 mV, and Vin = 1.3 V. The ratio Vout/ Vin expressed in dB is%!
A band-pass filter rejects all frequencies within a band between a lower and an upper critical frequency and passes all others.%!