An open belt drive is used when – McqOptions

MCQOPTIONS

1.	An open belt drive is used when
A.	shafts are arranged parallel and rotate in the opposite directions
B.	shafts are arranged parallel and rotate in the same directions
C.	shafts are arranged at right angles and rotate in one definite direction
D.	driven shaft is to be started or stopped whenever desired without interferring with the driving shaft
Answer» C. shafts are arranged at right angles and rotate in one definite direction

Discussion

No Comment Found

Related MCQs

Which of the following material has the maximum ductility?
In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft.
Slenderness ratio is the ratio of
Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that
The load cup of a screw jack is made separate from the head of the spindle to
The resistance to fatigue of a material is measured by
Stress concentration is caused due to
In a hydrodynamic lubricated bearing
Surface endurance limit of gear material is dependent upon its
According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test.