According to Unwin's formula, the relation between the diameter of riv – McqOptions

MCQOPTIONS

1.	According to Unwin's formula, the relation between the diameter of rivet hole ( d ) and the thickness of plate ( t ) is given by (where d and t are in mm)
A.	d = t
B.	d = 1.6 t
C.	d = 2 t
D.	d = 6 t
Answer» E.

Discussion

No Comment Found

Related MCQs

Which of the following material has the maximum ductility?
In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft.
Slenderness ratio is the ratio of
Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that
The load cup of a screw jack is made separate from the head of the spindle to
The resistance to fatigue of a material is measured by
Stress concentration is caused due to
In a hydrodynamic lubricated bearing
Surface endurance limit of gear material is dependent upon its
According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test.