A spindle speed of 300 rpm and a feed of 0.3 mm/revolution are chosen

1.

A spindle speed of 300 rpm and a feed of 0.3 mm/revolution are chosen for longitudinal turning operation on an engine lathe. In finishing pass, roughness on the work surface can be reduced by

A. reducing the spindle speed

B. increasing the spindle speed

C. reducing the feed of tool

D. increasing the feed of tool

Answer» D. increasing the feed of tool

Discussion

No Comment Found

Related MCQs

 The mathematical technique for finding the best use of limited resources in an optimum manner is known as

A company spends considerable amount on publicity to promote sales. This expenditure in break even chart is shown below the

Which of the following organisation is preferred in automobile industry?

 P.M.T.S. (Predetermined Motion Time Systems) include

 Which of the following statement is wrong?

Positive slack on a PERT indicates that project is

Product layout is best suited where

The performance of a specific task in CPM is known as

 PERT stands for

If standard production is 20 units, a worker’s actual output is 18 units, piece rate is Rs. 500 per unit, and over-achievement rate is Rs. 750 per unit, then the wage paid to the worker, in Rs., as per Taylor’s differential price rate wage incentive plan, is

1.	A spindle speed of 300 rpm and a feed of 0.3 mm/revolution are chosen for longitudinal turning operation on an engine lathe. In finishing pass, roughness on the work surface can be reduced by
A.	reducing the spindle speed
B.	increasing the spindle speed
C.	reducing the feed of tool
D.	increasing the feed of tool
Answer» D. increasing the feed of tool

A spindle speed of 300 rpm and a feed of 0.3 mm/revolution are chosen for longitudinal turning operation on an engine lathe. In finishing pass, roughness on the work surface can be reduced by

Discussion

No Comment Found

Related MCQs

Reply to Comment