A single reduction gear of 120 KW with a pinion of 150 mm pitch circle diameter and speed 550 rpm is supported in bearings on either side. Calculate the total load due to power transmission.

A single reduction gear of 120 KW with a pinion of 150 mm pitch circle

1.	A single reduction gear of 120 KW with a pinion of 150 mm pitch circle diameter and speed 550 rpm is supported in bearings on either side. Calculate the total load due to power transmission.
A.	28.20 KN
B.	35.21 KN
C.	40 KN
D.	45 KN
Answer» B. 35.21 KN

Discussion

No Comment Found

Related MCQs

Gear lubricant should be changed ____________
Miter gear is a type of ________
Cream separator has which gear?
Helical gear is used for transmitting the power between two ___________
Worm gear is used, when two shafts are at _________
In an epicyclic gear train, one arm carries two wheels A and B having 25 teeth and 35 teeth respectively. If the arm rotates at 100 rpm in clockwise direction about centre of wheel A which is fixed, then speed of wheel on its own axis will be?
In a tractor differential, the pinion on the propeller shaft has 12 teeth and the crown gear has 50 teeth. The propeller shaft rotates at 1500 rpm and the right rear axle rotates at 250 rpm while taking a left turn. The rotation of the left axle in rpm will be __________
A tractor has 8 forward speeds. The speed ratio varies in exact geometrical progressions. If the speed ratio in highest and lowest gear are 14.9:1 and 108:1, the geometrical constant will be __________
The speed reduction in 1<sup>st</sup> low gear of tractor box and differential with final drive are 5:1 and 45:1 for a tractor developing 30 KW at engine at an rpm of 2500 with overall efficiency of 85%. The torque is KN-m available at wheel axle?
In an epicyclic gear train, the sun gear on the input shaft is 20 teeth external gear. The planet gear is a 40 teeth external gear and the ring gear is a 100 teeth internal gear. The ring gear is fixed and the sun gear is rotating at 60 rpm counter clockwise. The arm attached to output shaft will rotate at ________

A single reduction gear of 120 KW with a pinion of 150 mm pitch circle diameter and speed 550 rpm is supported in bearings on either side. Calculate the total load due to power transmission.

Discussion

No Comment Found

Related MCQs

Reply to Comment