A single phase half wave converter is used to charge a battery of 50 V – McqOptions

MCQOPTIONS

1.	A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin t. The thyristor will conduct
A.	from 0 to 180
B.	when v > 50 V
C.	from 0 to 90
D.	When v < 50 V
Answer» C. from 0 to 90

Discussion

No Comment Found

Related MCQs

In a flyback converter, the inductor of the buck-boost converter has been replaced by a
The amount of dielectric heating is inversely proportional to frequency.
In current commutated DC-DC choppers, the voltage spike appears across the load when
Voltage commutation circuit can be converted into a current commutation by interchanging the positions of
The advantage of using free - wheeling diode in half controlled bridge converter is that
In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes
The input current waveform of a bridge controlled rectifier when the load is perfectly filtered is
If all the SCR s of 3 phase PAC is replaced by diodes, they would be triggered
A single phase step up cycloconverter changes 50 Hz to 100 Hz. Then one half wave of input will give rise to
A thyristor is reverse biased. A positive gate pulse is applied. The thyristor