A single 6 V pulse with a width of 600 μs is applied to an integrato – McqOptions

MCQOPTIONS

1.	A single 6 V pulse with a width of 600 μs is applied to an integrator consisting of a 150 kΩ resistor and a 0.002 μF capacitor. To what voltage will the capacitor charge?
A.	0 V
B.	3.78 V
C.	5.16 V
D.	6 V
Answer» D. 6 V

Discussion

No Comment Found

Related MCQs

If the capacitor in an integrator shorts, the output
An integrator and an differentiator can act as what types of filters, respectively?
In a repetitive-pulse integrator circuit, what would the steady-state voltage equal at the end of the fifth pulse? Assume a of 20 V.
If the output of an integrator is zero volts, the capacitor might be open.
The voltage across a capacitor in an integrator circuit cannot change exponentially; it can change only instantaneously.
If a repetitive-pulse waveform is applied to an integrator, the output waveshape depends on the relationship of the circuit time constant and the duty cycle of the input pulses.
A repetitive pulse with a 50% duty cycle is being applied to the input of an integrator. If one time constant is less than one-fifth the pulse width, the capacitor will be able to fully charge and discharge.
A(n) _____ will decrease the time constant in an integrator or differentiator.
For a capacitor to completely charge in an integrator, the pulse width must be _____ 5 time constants.
In an electric circuit, the reaction of a circuit to a given pulse input is known as the pulse response.