A shell may by termed as thin if its thickness to diameter ratio is le – McqOptions

MCQOPTIONS

1.	A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is%!
A.	Bending
B.	Deformation
C.	Shear
D.	Elongation
Answer» B. Deformation

Discussion

No Comment Found

Related MCQs

With increase in temperature drop (in a shell and tube heat exchanger), the correction factor,
In a double pipe concentric heat exchanger, the equivalent diameter of annulus for heat transfer would be (where, and are I.D. of inner and outer pipes)
Joint efficiency () for a seamless pipe is
In common bubble cap distillation column design practice, riser area is approximately equal to (where, = Annular passage area, and = Slot area)
The absorption factor is defined as (where, = slope of the equilibrium curve, = slope of the operating line)
In the design of a paddle agitator, the ratiois normally taken as
Stress-strain diagram for low carbon steel/mild steel is shown below in the Fig. The point '' on the Fig. represents the
In a multiple effect evaporator system having '' effects, the amount of water evaporated per unit surface area in approximately equal to __________ times that in a single effect.
The correction factor () is applied in __________ heat exchangers.
for couplings and unions would be