A power system network is connected as shown in the figure. Sd1=15+j5 puSd2=25+j15 puZcable = j0.05pu|V1|=|V2|=1 pu.The torue angle for the system will be __________

A power system network is connected as shown in the figure. Sd1=15+j5

1.	A power system network is connected as shown in the figure. Sd1=15+j5 puSd2=25+j15 puZcable = j0.05pu\|V1\|=\|V2\|=1 pu.The torue angle for the system will be __________
A.	14.4
B.	22.1
C.	16.2
D.	18.2
Answer» B. 22.1

Discussion

No Comment Found

Related MCQs

A three phase transformer has a nameplate rating of 30 MVA, 230Y/69Y kV with a leakage -reactance of 10% and the transformer connection is wye-wye. Choosing a base of 30MVA and 230 kV on high voltage side, the transformer reactance referred to the high voltage side will be _________(in ohms).
A three phase transformer has a nameplate rating of 30 MVA, 230Y/69Y kV with a leakage -reactance of 10% and the transformer connection is wye-wye. Choosing a base of 30MVA and 230 kV on high voltage side, the low voltage side impedance is ___________
A three phase transformer has a nameplate rating of 30 MVA, 230Y/69Y kV with a leakage -reactance of 10% and the transformer connection is wye-wye. Choosing a base of 30MVA and 230 kV on high voltage side, the high voltage side impedance ____________
A three phase transformer has a nameplate rating of 30 MVA, 230Y/69Y kV with a leakage -reactance of 10% and the transformer connection is wye-wye. Choosing a base of 30MVA and 230 kV on high voltage side, the reactance of transformer in per units is __________
A single phase TL has copper conductor of 0.775 cm2 cross section through which 200 kW at UPF at 330 V is to be maintained. If the efficiency of transmission line is 90%, then the minimum length of TL is ___________(in km and take specific resistance to be 1.785 μΩ/cm).
A 50 Hz four pole turbo-generator rated 100 MVA, 11 kV has an inertia constant of 8 MJ/MVA. If the mechanical input is suddenly raised to 80 MW for an electrical load of 50MW, then the rotor acceleration is ____________
A 100 MVA synchronous generator operates on full load at a frequency of 50 Hz. The load is suddenly reduced to 50 MW. Due to time lag in governor system, the steam valve begins to close after 0.4s. The change in the frequency is ________(H=5 kW-s/KVA).
A power system has a maximum load of 15 MW. Annual load factor is 50%. The reserve capacity of plant is _____ if the plant capacity factor is 40%.
A 275 kV TL has following line constants A=0.85ʟ5o, B=200ʟ75o. The active power angle such that the voltage to be maintained at the other end will be 275 kV ____________
A 275 kV TL has following line constants A=0.85ʟ5o, B=200ʟ75o. The active power received if the voltage to be maintained is 275kV will be __________

A power system network is connected as shown in the figure. Sd1=15+j5 puSd2=25+j15 puZcable = j0.05pu|V1|=|V2|=1 pu.The torue angle for the system will be __________

Discussion

No Comment Found

Related MCQs

Reply to Comment